Kia Rio: Driving your vehicle

Kia Rio 2017-2025 YB Owners Manual / Driving your vehicle

Be sure the exhaust system does not leak.

The exhaust system should be checked whenever the vehicle is raised to change the oil or for any other purpose. If you hear a change in the sound of the exhaust or if you drive over something that strikes the underneath side of the vehicle, have the exhaust system checked as soon as possible by an authorized Kia dealer.

WARNING - Engine exhaust

Do not inhale exhaust fumes or leave your engine running in an enclosed area for a prolonged time.

Exhaust fumes contain carbon monoxide, a colorless, odorless gas that can cause unconsciousness and death by asphyxiation.

WARNING - Open trunk/liftgate

Do not drive with the trunk/liftgate open.

Poisonous exhaust gases can enter the passenger compartment. If you must drive with the trunk/liftgate open proceed as follows:

1.Close all windows.

2.Open side vents.

3.Set the air intake control at “Fresh”, the air flow control at “Floor” or “Face” and the fan at the highest speed.

Covering shelf (for 5 Door)
Use the cover to hide items stored in the cargo area. The covering shelf will be lifted when the liftgate is opened. Disconnect the strap (1) from holder if you want to return the cover to origin ...

Before driving
Before entering vehicle Be sure that all windows, outside mirror(s), and outside lights are clean. Check the condition of the tires. Check under the vehicle for any sign of leaks. Be sure th ...

Other information:

Kia Rio 2017-2025 YB Owners Manual: Tire rotation


To equalize tread wear, it is recommended that the tires be rotated every 12,000 km (7,500 miles) or sooner if irregular wear develops. During rotation, check the tires for correct balance. When rotating tires, check for uneven wear and damage. Abnormal wear is usually caused by incorrect tire ...

Kia Rio 2017-2025 YB Service Manual: General Service Information


General information Identification Number Locations Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work.    The support rod must be inserted into the hole near the ...

Copyright © www.krioyb.com 2017-2025