Kia Rio: Special driving conditions / Smooth cornering, Driving at night

Smooth cornering

Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be held to a minimum.

Driving at night

Because night driving presents more hazards than driving in the daylight, here are some important tips to remember:

  • Slow down and keep more distance between you and other vehicles, as it may be more difficult to see at night, especially in areas where there may not be any street lights.
  • Adjust your mirrors to reduce the glare from other driver's headlights.
  • Keep your headlights clean and properly aimed on vehicles not equipped with the automatic headlight aiming feature. Dirty or improperly aimed headlights will make it much more difficult to see at night.
  • Avoid staring directly at the headlights of oncoming vehicles. You could be temporarily blinded, and it will take several seconds for your eyes to readjust to the darkness.

    If it is necessary to rock the vehicle to free it from snow, sand, or mud, first turn the steering wheel right and left to clear the area around your front wheels.

    Rain and wet roads can make driving dangerous, especially if you’re not prepared for the slick pavement. Here are a few things to consider when driving in the rain: A heavy rainfall will make it harder to see and will increase the distance needed to stop your vehicle, so slow down.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Power Window Motor

    Components and components location Components [Standard window motor] [Safety window motor] Repair procedures Inspection    • When removing with a flat-tip screwdriver or remover, wrap protective

    Kia Rio 2017-2023 YB Service Manual: Blower Resistor (MANUAL)

    Repair procedures Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Categories

     
    Copyright © 2025 www.krioyb.com - 0.012