
If any method other than the CRUISE button was used to cancel cruising speed and the system is still activated, the most recent set speed will automatically resume when you move the lever up (to RES+).
It will not resume, however, if the vehicle speed has dropped below approximately 30 km/h (20 mph).
✽ NOTICE
Always check the road conditions before you move the lever up (to RES+) to resume the speed.
Depress the brake pedal. Depress the clutch pedal with a Manual Transmission. Shift into N (Neutral) with an Intelligent Variable Transmission.
Press the CRUISE button (the CRUISE indicator light in the instrument cluster will go off). Turn the ignition off. Both of these actions cancel cruise control operation.
Repair procedures Inspection Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect positive (+) battery cables to terminal 4 and negative (-) battery cables to terminal 3 respectively.
Components and components location Components Connector Pin Information No. Connector A Connector B Connector C 1 - IGN2 Relay_output Battery (+)_Signal 2 SSB Switch1 signal_input P-CAN