Kia Rio: Heater / Temperature Control Actuator

Kia Rio 2017-2025 YB Service Manual / Heating,Ventilation, Air Conditioning / Heater / Temperature Control Actuator

Description and operation
Description

The heater unit includes mode control actuator and temperature control actuator.

The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. Signal from control unit adjusts position of temperature door by operating temperature switch and then temperature will be regulated by the hot/cold air ratio decided by position of temperature door.

Repair procedures
Inspection
1.

Turn the ignition switch OFF.

2.

Disconnect the temperature control actuator connector.

3.

Verify that the temperature control actuator operates to the warm (LHD) or cool (RHD) position when connecting 12V to the terminal 3 and grounding terminal 4.

Verify that the temperature control actuator operates to the cool (LHD) or warm (RHD) position when connecting in the reverse.

1. -
2. -
3. Cool position
4. Warm position
5. Sensor (+ 5V)
6. Feedback signal
7. Sensor ground

4.

Connect the temperature control actuator connector.

5.

Turn the ignition switch ON.

6.

Check the voltage between terminal 6 and 5 (LHD) or 7 (RHD).

Specification

Door position
Voltage (V)
Error detecting
Max. cooling
0.4
Low voltage : 0.1V or less
Max. heating
4.6
High voltage : 4.9V or more

It will feedback current position of actuator to controls.

7.

If the measured voltage is not specification, substitute with a known-good temperature control actuator and check for proper operation.

8.

If the problem is corrected, replace the temperature control actuator.

Replacement
1.

Disconnect the negative (-) battery terminal.

2.

Remove the driver side shower duct (A) after loosening the screw.

3.

Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws.

4.

Installation is the reverse order of removal.

Heater Unit
Components and components location Component Location Components 1. Heater pipe cover 2. Heater core 3. Mode control actuator 4. Mode control a ...

Mode Control Actuator
Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of ...

Other information:

Kia Rio 2017-2025 YB Owners Manual: Checking the amount of air conditioner refrigerant and compressor lubricant


When the amount of refrigerant is low, the performance of the air conditioning is reduced. Overfilling also has a negative influence on the air conditioning system. Therefore, if abnormal operation is found, have the system inspected by an authorized Kia dealer. The refrigerant label is loca ...

Kia Rio 2017-2025 YB Service Manual: Vanity Lamp


Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the vanity lamp (A) using a flat-tip screwdriver. 3. Disconnect the vanity lamp connector (A). Bulb Replace ...

Copyright © www.krioyb.com 2017-2025