Kia Rio: Cooling System / Water Temperature Control Assembly

Kia Rio 2017-2023 YB Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly

Repair procedures

Removal and Installation
1.

Remove the engine room under cover.

(Refer to Engine and Transaxle Assembly - "Engine Room Under cover")

2.

Drain the coolant.

(Refer to Cooling System - "Coolant")

3.

Remove the air cleaner assembly.

(Refer to Intake and Exhaust System - "Air Cleaner")

4.

Remove the battery.

(Refer to Engine Electrical System - "Battery")

5.

Disconnect the radiator upper hose (A).
6.

Disconnect the heater hose (A).
7.

Disconnect the coolant hose (A).
8.

Disconnect the vacuum hose (A).
9.

Disconnect the engine coolant temperature sensor (ECTS) connector (A).
10.

Remove the water temperature control assembly (A).

Tightening torque :

18.6 - 23.5 N·m (1.9 - 2.4 kgf·m, 13.7 - 17.4 lb·ft)

11.

Install in the reverse order of removal.
12.

Fill the coolant.

(Refer to Cooling System - "Coolant")

13.

Start the engine and check for leasks.
14.

Recheck the engine coolant level.

    Components and components location Components 1. Radiator 2. Radiator upper hose 3. Radiator lower hose 4. Filler neck assembly 5.

    Repair procedures Removal and Installation 1. Disconnect the battery negative terminal. 2. Drain the coolant.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Instrument Cluster

    Components and components location Components [Standard Type ("3.5")] [Supervision Type ("3.5")] Connector Pin Information Connector A No.

    Kia Rio 2017-2023 YB Service Manual: Rear Glass Defogger Printed Heater

    Repair procedures Inspection    • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply pressure on the tin foil with hand and move the tin foil along the grid line to check for open circ

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0154