Kia Rio: Rear Door / Rear Door Window Glass

Components and components location

Component Location

1. Rear door window glass


Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the rear door trim.

(Refer to Rear Door - "Rear Door Trim")

2.

Remove the door pull handle mounting support (A) after loosening the screws.

3.

Disconnect the front door speaker connector (A), and then remove the wiring mounting clips.

4.

Remove the front door trim seal (A).

5.

Remove the front door belt inside weather strip (A).

6.

Remove the front door belt outside weather strip (A).

7.

Separate the door side weatherstrip (A).

8.

Loosen the mounting screw and nut.

9.

Remove the quarter fixed glass & molding (A).

10.

Remove the rear door window glass (A) after loosening the mounting bolts.

  

Be careful not to drop the glass and/or scratch the glass surface.

  

Use the door switch to align the mounting bolt in the door.

If the window motor cannot be operated, remove the motor and align the hole by hand.

11.

Install in the reverse order of removal.

  

Check that glass operation is normal.

Check the damage glass channel, and replace if necessary.

Adjust glass if necessary.

    Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

    Components and components location Component Location 1. Rear door trim Repair procedures Replacement    Put on gloves to protect your hands.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Power Window Switch

    Components and components location Components Driver Power Window Switch Connector Pin Information [Front / Rear Driver Safety - Auto Up/Down] [LHD] No. Description No. Description 1 Front right power window (Up) 10

    Kia Rio 2017-2023 YB Service Manual: Cluster Ionizer (FATC only)

    Description and operation Description The cluster ionizer helps to clean up odors in the vehicle or from the air-conditioner system. When the ignition switch ON, the inoizer runs a "CLEAN" mode and then a "ION" mode, switching every about 15 minutes.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0135