| Component Location |

| 1. Headlamp assembly (Built in
leveling actuator) |
2. Headlamp leveling switch
|
Components and components location Component Location I/P Junction Block Circuit (I/P Junction Block) Repair procedures Fuse Inspection 1.
Components and components location Components Repair procedures Removal 1. Disconnect the negative (-) battery terminal.
Repair procedures Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1.
Repair procedures Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed.