| Replacement |
| 1. |
Remove the crankshaft damper pulley. (Refer to Drive Belt System - "Crankshaft Damper Pulley") |
| 2. |
Remove the front oil seal (A).
|
| 3. |
Using the SST (09214-1R000, 09231-H1100) (A), install a new front oil seal (B), apply engine oil on the edge of new oil seal.
|
Repair procedures Removal Engine removal is not required for this procedure. • Use fender covers to avoid damaging painted surfaces.
Components and components location Components Repair procedures Removal When replacing the LDWS switch, check that the symbol mark in the cluster operates normally by pressing the ON/OFF switch.
Repair procedures Oil Specification 1. The HFC-134a system requires synthetic compressor oil (PAG) whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor oil (PAG) varies according to compressor model.