Kia Rio: Front Door / Front Door Belt Outside Weatherstrip

Kia Rio 2017-2023 YB Service Manual / Body (Interior and Exterior) / Front Door / Front Door Belt Outside Weatherstrip

Repair procedures

Replacement
  

Put on gloves to protect your hands.

  
•

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•

Be careful not to bend or scratch the trim and panels.

1.

Separate the front door quadrant inner cover (A) by using a or remover.

2.

Remove the front door tweeter speaker connector (A).

3.

Disconnect the outside rear view mirror connector (A) and loosen the nuts (B).

4.

Remove the outside rear view mirror (A).

5.

Remove the front door belt outside weather strip (A).

6.

Install in the reverse order of removal.

  
•

Make sure that the connector is connected properly.

•

Make sure that the door locks/unlocks and opens/closes properly.

•

Replace any damaged clips.

    Repair procedures Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2.

    Repair procedures Replacement 1. Loosen the front door checker (B) mounting bolt. Tightening torque : 19.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Compressor

    Description and operation Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of engine. The compressor changes the low pressure and low temperature refrigerant gas into the high pressure and high temperature refrigerant gas.

    Kia Rio 2017-2023 YB Service Manual: Intake Actuator

    Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by signal from control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0185