| Replacement |
Put on gloves to protect your hands. |
|
| 1. |
Remove the console front complete assembly. (Refer to Floor Console - "Floor Console Assembly") |
| 2. |
Remove the accelerator pedal. (Refer to Engine Control System - "Accelerator Position Sensor (APS)") |
| 3. |
Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly") |
| 4. |
Remove the rear seat assembly. (Refer to Rear Seat - "Rear Seat Assembly") |
| 5. |
Remove the cowl side trim. (Refer to Interior Trim - "Cowl Side Trim") |
| 6. |
Remove the center pillar lower trim. (Refer to Interior Trim - "Center Pillar Trim") |
| 7. |
Remove the luggage side trim. (Refer to Interior Trim - "Luggage Side Trim") |
| 8. |
Remove the floor carpet assembly (A). |
| 9. |
Install in the reverse order of removal.
|
Components and components location Component Location 1. Fender assembly Repair procedures Replacement • Be careful not to damage the fender and body.
Components and components location Components [DLX] 1. Floor console assembly 2. Rear console cover 3. Console armrest 4.
Repair procedures Smart Key Smart Key Code Saving 1. Connect the DLC cable of KDS/GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on KDS/GDS. 2. Select the vehicle model and then do "Smart key code saving".
Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Remove the glass motor (A) after loosening the mounting screws.