Kia Rio: Driveshaft Assembly / Dynamic Damper
Components and components location
| Components |
| [RH] |
| 1. BJ assembly 2. Clip 3. BJ boot band 4. BJ boot |
5. Dynamic damper band
6. Dynamic damper 7. Shaft 8. TJ boot band |
9. TJ boot
10. Spider assembly 11. Circlip 12. TJ housing |
13. Circlip |
| [LH] |
| 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot |
5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly |
9. Snap
ring 10. TJ case 11. Circlip |
Repair procedures
| Replacement |
| 1. |
Remove the front driveshaft. (Refer to Driveshaft and axle - “Front Driveshaft”) |
| 2. |
Remove the TJ joint assembly. (Refer to Driveshaft and axle - “TJ joint”) |
| 3. |
Remove the remove the both side of band (B) of the dynamic damper (A).
|
| 4. |
Fix the driveshaft (A) with a vice (B) as illustrated.
|
| 5. |
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper when the dynamic damper is removed. |
| 6. |
Seperate the dynamic damper (A) from the shaft (B) carefully.
|
| Installation |
| 1. |
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. |
| 2. |
Install the dynamic damper. |
| 3. |
Install the dynamic damper band (A). |
| 4. |
Using the SST(09495-3K000), secure the TJ boot bands (B).
|
| 5. |
Install the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint”) |
| 6. |
Install the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) |
| 7. |
Check the front alignment. (Refer to Suspension System - "Alignment") |
TJ Joint
Components and components location
Components
[RH]
1. BJ assembly
2. Clip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynami ...
BJ Boot
Components and components location
Components
[RH]
1. BJ assembly
2. Clip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynami ...
Other information:
Kia Rio 2017-2025 YB Service Manual: Rear Seat Belt Buckle
Components and components location Component Location 1. Rear seat belt buckle [RH] 2. Rear seat belt buckle [LH] Repair procedures Replacement When installing t ...
Kia Rio 2017-2025 YB Owners Manual: Stop and tail lamp / Side marker (Bulb type) replacement (for 4 door)
1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 4. Remove the bulb from the socket by pressing it in and rota ...
