| Components |

| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Open the sunglass case cover from the overhead console and remove the 2 screws holding the overhead console. Disconnect the switch connector and Map lamp connector, and then remove the overhead console lamp (A).
|
| 3. |
Check for continuity between the terminals. If the continuity is not shown as specified, replace the panoramaroof switch.
|
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the overhead console lamp. (Refer to Lighting System - "Overhead Console Lamp") |
| 3. |
Remove the sunroof switch knob (A).
|
| 4. |
Remove the sunroof bulb base (A) after loosening the mounting screws.
|
| 5. |
Remove the sunroof switch assembly (A) after loosening the mounting screws.
|
| Installation |
| 1. |
Install the sunroof switch assembly. |
| 2. |
Install the sunroof bulb base. |
| 3. |
Install the sunroof switch knob. |
| 4. |
Install the overhead console lamp. |
| 5. |
Connect the negative (-) battery terminal. |
Components and components location Component Location 1. Sunroof 2. Sunroof switch 3. Sunroof motor & controller Schematic diagrams Circuit Diagram
Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly.
Repair procedures Inspection Front Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. • Before filling the reservoir tank wi
Description and operation Description The photo sensor is located at the center of defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving portion, generates an electromotive force in proportion to the amount of radiation received which is tran