| Specification | 
| Item | Specification | 
| Type | Normal open | 
| Input voltage | 12 V | 
| Coil resistance | 3.5 ± 0.2 Ω (at 25°C, 77°F) | 
| Frequency | 50 Hz | 
| Component Location | 

| 1. Overdrive clutch control solenoid 
		valve (PCSV-A) 2. ON/OFF solenoid valve (SCSV-A) 3. Torque converter control solenoid valve (PCSV-D) | 4. Underdrive clutch control 
		solenoid valve (PCSV-C) 5. 24 brake control solenoid valve (PCSV-B) 6. Solenoid valve support bracket | 
| Description | 
| • | Torque converter control solenoid valve is a PWM (Pulse Width Modulation) type. | 
| • | When TCM supplies current to solenoid valve, hydraulic pressure of torque converter clutch is controlled by solenoid valve. 
		 | 
Solenoid valve operation table
| Range | PCSV-D | 
| N, P | ● | 
| 1 |  | 
| 2 |  | 
| 3 |  | 
| 4 | ● | 
| R | ● | 
| Circuit Diagram | 

| Inspection | 
| 1. | Switch "OFF" ignition. | 
| 2. | Remove the air cleaner. (Refer to Engine Mechanical System - "Air cleaner") | 
| 3. | Disconnect the main connector (A). 
		 | 
| 4. | Measure the resistance between ground terminal (7) and signal terminal (4). 
 | 
| Removal | 
| 1. | Remove the valve body assembly (Refer to Hydraulic System - "Valve Body") | 
| 2. | Disconnect the main harness (A). 
		 | 
| 3. | Remove solenoid valve support bracket (A) after loosening the bolts. 
 
		 | 
| 4. | Remove the torque converter control solenoid valve (A). 
		 | 
| Installation | 
| 1. | Install in the reverse order of removal. | 
| 
 When installing, apply the ATF or petroleum jelly to the O-ring to prevent damage. 
		 | 
 Hydraulic System
Hydraulic System 24 Brake Control Solenoid Valve (PCSV-B)
24 Brake Control Solenoid Valve (PCSV-B)