Kia Rio: Rear Seat / Rear Seat Cushion Cover

Kia Rio 2017-2023 YB Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Cushion Cover

Components and components location

Component Location

1. Rear seat cushion cover

Repair procedures

Replacement

Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the seat assembly. (Refer to Rear Seat - "Rear Seat Assembly")

2.	Remove the rear seat cushion cover (A) after removing the hog-ring clips on the rear of seat cushion cover.

Install in the reverse order of removal.

•	Make sure that the connectors are plugged in properly.

•	Replace any damaged clips.

•	To prevent wrinkles, make sure that the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).

•	Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

❮Rear Seat Back Cover

Components and components location Component Location 1. Rear seat back cover [LH] 2. Rear seat back cover [RH] Repair procedures Replacement Put on gloves to protect your hands.

Rear Seat Belt❯

Other information:

Kia Rio 2017-2023 YB Service Manual: Mode Control Actuator

Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

Kia Rio 2017-2023 YB Service Manual: Power Mosfet (FATC)