Kia Rio: Cylinder Block / Rear Oil Seal

Kia Rio 2017-2023 YB Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal

Repair procedures

Replacement
1.

Remove the transaxle assembly.

(Refer to Manual Transaxle System - "Manual Transaxle")

(Refer to Automatic Transaxle System - "Automatic Transaxle")

2.

MT : Remove the flywheel.

(Refer to Cylinder Block - "Flywheel")

AT : Remove the drive plate.

(Refer to Cylinder Block - "Drive Plate")

3.

Remove the rear oil seal (A)
4.

Install the new rear oil seal.

(1)

Apply engine oil on the edge of new oil seal.
(2)

Using the SST (09231-H1100, 09214-03100) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

  

Always use new rear oil seal.
5.

Install the other parts in the reverse order of removal.

    Repair procedures Removal 1. Remove the manual Transaxle. (Refer to Manual Transaxle System - "Manual Transaxle") 2.

    Repair procedures Disassembly    • Use fender covers to avoid damaging painted surfaces.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Windshield Wiper-Washer Switch

    Repair procedures Removal [BCM Type] 1. Disconnect the negative (-) battery terminal. 2. Remove the steering wheel. (Refer to Steering System - "Steering Wheel") 3.

    Kia Rio 2017-2023 YB Service Manual: Mode Control Actuator

    Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0165