Kia Rio: Lighting System / Rear Combination Lamp
Repair procedures
| Removal |
Rear Combination Lamp (Outside)
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the rear combination lamp (A) after loosening the mounting screws.
|
| 3. |
Remove the rear combination lamp packing (A).
|
| 4. |
Disconnect the rear combination lamp connector (A).
|
| Bulb Replacement |
Turn Signal Lamp
| 1. |
Turn the headlamp switch off. |
| 2. |
Remove the rear combination lamp (outside). |
| 3. |
Remove the turn signal lamp bulb (B) by turning the socket (A) counterclockwise.
|
Rear Combination Lamp (Inside)
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Using a screwdriver or remover, remove the rear combination lamp cover (A).
|
| 3. |
Disconnect the connector (B) and then remove the rear combination lamp (A) after loosening the nuts.
|
| Bulb Replacement |
Back up lamp
| 1. |
Using a screwdriver or remover, remove the rear combination lamp cover (A).
|
| 2. |
Remove the back up lamp bulb (B) by turning the socket (A) counterclockwise.
|
| Installation |
Rear Combination Lamp (Outside)
| 1. |
Connect the rear combination lamp connector. |
| 2. |
Install the rear combination lamp. |
| 3. |
Connect the negative (-) battery terminal. |
Rear Combination Lamp (Inside)
| 1. |
Install the rear combination lamp. |
| 2. |
Connect the rear combination lamp connector. |
| 3. |
Install the rear combination lamp cover. |
| 4. |
Connect the negative (-) battery terminal. |
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Open the tailgate.
Specifications Specifications Items Specifications Rated voltage DC 12 V Operating temperature range -22 - 176°F (-30 - 80°C) Rated load Washer Washer : 6A (Motor load) Components and components location Components [BCM Type] 1 .
Other information:
Kia Rio 2017-2023 YB Service Manual: Power Door Lock Switch
Repair procedures Removal • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Kia Rio 2017-2023 YB Service Manual: Intake Actuator
Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by signal from control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.
Categories
- Manuals Home
- Kia Rio Owners Manual
- Kia Rio Service Manual
- Engine Mechanical System
- Maintenance Schedule
- Maintenance
- New on site
- Most important about car
