Kia Rio: Lighting System / License Lamps
Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the license lamp assembly (A) after pressing the locking pin.
|
| 3. |
Disconnect the license lamp connector (A).
|
| 4. |
Remove the license lamp bulb (B) after removing the license lamp socket (A).
|
| Installation |
| 1. |
Install the license lamp bulb. |
| 2. |
Connect the license lamp connector. |
| 3. |
Install the license lamp assembly. |
| 4. |
Connect the negative (-) battery terminal. |
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper assembly.
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Open the tailgate.
Other information:
Kia Rio 2017-2023 YB Service Manual: Overhead Console Lamp
Repair procedures Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1.
Kia Rio 2017-2023 YB Service Manual: Mode Control Actuator
Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Categories
- Manuals Home
- Kia Rio Owners Manual
- Kia Rio Service Manual
- Body (Interior and Exterior)
- Suspension System
- General Information
- New on site
- Most important about car
