| Inspection |
Visually check the fuel lines for cracks, leakage, loose connections, deformation or tank band looseness.
Repair procedures Replacement 1. Turn ignition switch OFF and disconnect the negative (-) battery terminal. 2.
Repair procedures Inspection Manual Transaxle Oil Level Check 1. Stop the engine and then raise the vehicle using the lift.
Repair procedures Inspection Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect positive (+) battery cables to terminal 4 and negative (-) battery cables to terminal 3 respectively.
Repair procedures Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.