| Component Location |

| 1. Fuel filler door |
| Replacement |
Use a plastic panel removal tool to remove interior trim pieces without marring the surface. |
| 1. |
Open the fuel filler door and then filler door cap.
|
| 2. |
Remove the fuel filler door (A) after loosening the mounting screws.
|
| 3. |
Install in the reverse order of removal.
|
Repair procedures Replacement 1. Loosen the front door checker (B) mounting bolt. Tightening torque : 19.
Components and components location Components 1. Front seat back pad 2. Front seat back heater 3. Front seat back covering 4.
Repair procedures Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1.
Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.