Kia Rio: ESC (Electronic Stability Control) System / Front Wheel Speed Sensor

Kia Rio 2017-2023 YB Service Manual / Brake System / ESC (Electronic Stability Control) System / Front Wheel Speed Sensor

Components and components location

Components

1. Front wheel speed sensor connector

2. Front wheel speed sensor

Repair procedures

Removal

Remove the front wheel & tire.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

Loosen the bolt (A) and then disconnect the wheel speed sensor.

Tightening torque :

7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

3.	Remove the front wheel guard. (Refer to Body - "Front Wheel Guard")

4.	Disconnect the wheel speed sensor connector (A).

5.	Install in the reverse order of removal.

Inspection

Measure the output voltage between the terminal of the wheel speed sensor and the body ground.

In order to protect the wheel speed sensor, when measuring output voltage, a 100 Ω resister must be used as shown.

Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low : 0.59V - 0.84V

V_high : 1.18V - 1.68V

Frequency range : 1 - 2,500Hz

❮ESC Control Module

Components and components location Components 1. ESC control module connector 2. ESC control module 3. ESC bracket Repair procedures Removal 1.

Rear Wheel Speed Sensor❯

Components and components location Components Drum type Disc type Repair procedures Removal 1. Remove the rear wheel & tire.

Other information:

Kia Rio 2017-2023 YB Service Manual: Immobilizer System

Schematic diagrams Circuit Diaram Description and operation Description The immobilizer system will disable the vehicle unless the proper ignition key is used, in addition to the currently available anti-theft systems such as car alarms, the immobilizer system aims to drastically reduce the rate of auto theft.

Kia Rio 2017-2023 YB Service Manual: Rear Wiper Motor