Kia Rio: Drive Belt System / Drive Belt Tensioner

Kia Rio 2017-2022 YB Service Manual / Engine Mechanical System / Drive Belt System / Drive Belt Tensioner

Repair procedures
Removal and Installation
1.

Remove the engine room under cover.

(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")

2.

Remove the drive belt.

(Refer to Drive Belt System - "Drive Belt")

3.

Remove the drive belt tensioner (A).

Tightening torque :

19.6 - 26.5 N·m (2.0 - 2.7 kgf·m, 14.5 - 19.5 lb·ft)

4.

Install in the reverse order of removal.

Inspection

Check the drive belt tensioner for excessive foreign substances, crack, damage or sticking of pivot shaft. Replace if necessary.

Drive Belt
Repair procedures Removal and Installation 1. Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") ...

Crankshaft Damper Pulley
Repair procedures Removal and Installation 1. Remove the engine room front under cover and RH side cover. (Refer to Engine and Transaxle Assembly - "Engine Room Und ...

Other information:

Kia Rio 2017-2022 YB Owners Manual: Electronic Stability Control (ESC) OFF, Immobilizer Indicator Lights


Electronic Stability Control (ESC) OFF Indicator Light This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When you deactivate the ESC system by pressing the ESC ...

Kia Rio 2017-2022 YB Owners Manual: Tail lamp (inside) bulb replacement (for 5 door)


1. Open the liftgate. 2. Remove the service cover. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 4. Remove the bulb from bulb-socket by pulling it out. 5. Insert a new bulb by inserting it in ...

Copyright © www.krioyb.com 2017-2022