Kia Rio: Crash Pad / Crach Pad Center Panel

Components and components location

Component Location

1. Crash pad center lower panel


Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Disconnect the negative (-) battery terminal.

2.

Remove the floor console assembly.

(Refer to Floor Console - "Floor Console Assembly")

3.

Remove the cluster fascia panel.

(Refer to Crash Pad - "Cluster Fascia Panel ")

4.

Remove the crash pad lower panel [LH].

(Refer to Crash Pad - "Crash Pad Lower Panel")

5.

Remove the center fascia panel.

(Refer to Crash Pad - "Center Fascia Panel")

6.

Remove the heater control unit.

(Refer to Heating,Ventilation And Air Conditioning - "Heater & A/C Control Unit (FATC)")

7.

Remove the crash pad center lower panel (A) after loosening the screws.

8.

Disconnect the start/stop button connector (A) and hazard switch connector (B).

9.

Install in the reverse order of removal.

  

Make sure the connector is connected properly.

Replace any damaged clips.

    Components and components location Component Location 1. Steering column shroud lower panel 2. Steering column shroud upper panel Repair procedures Replacement [Steering column shroud upper panel]    Put on gloves to protect your hands.

    Components and components location Component Location 1. Main crash pad assembly Repair procedures Replacement    Put on gloves to protect your hands.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Compressor Oil

    Repair procedures Oil Specification 1. The HFC-134a system requires synthetic compressor oil (PAG) whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. 2. Compressor oil (PAG) varies according to compressor model.

    Kia Rio 2017-2023 YB Service Manual: Receiver-Drier

    Repair procedures Replacement 1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with L wrench (A). Tightening torque : 2.7~3.2 N.m (0.28~0.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0143