| Inspection |
Vapor hose
| 1. |
Check all the clamps for tightness and the connections for leakage. |
| 2. |
Visually check the vapor lines and hoses for cracks, leaks, loose connections, or deformation. |
Fuel filler cap
| 1. |
Visually check that the fuel tank cap assembly and gasket (A) are not deformed or damaged.
|
Repair procedures Inspection [Kappa 1.0 T-GDI] Check the valve clearance. If necessary, adjust the valve clearance by replacing the tappets.
Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Components and components location Components Connector pin function NO. Connector A Connector B 1 Low Battery 2 Common ISG Battery 3 High Illumination (+)