Kia Rio: Cruise Control system / To cancel cruise control, do one of the following
- Depress the brake pedal.
- Depress the clutch pedal with a Manual Transmission.
- Shift into N (Neutral) with an Intelligent Variable Transmission.
- Press the CANCEL button.
- Decrease the vehicle speed lower than the memory speed by 20 km/h (12 mph
).
- Decrease the vehicle speed to less than approximately 30 km/h (20 mph).
Each of these actions will cancel cruise control operation (the SET indicator
light in the instrument cluster will go off), but it will not turn the system off.
If you wish to resume cruise control operation, move up the lever (to RES+) located
on your steering wheel.You will return to your previously preset speed.
To increase cruise control set speed:
Follow either of these procedures:
Move the lever up (to RES+) and hold it.Your vehicle will accelerate. Release
the lever at the speed you want.
Move ...
If any method other than the CRUISE button was used to cancel cruising speed
and the system is still activated, the most recent set speed will automatically
resume when you move the lever up (to ...
Other information:
Description and operation
Description
The heater unit includes mode control actuator and temperature control actuator.
The temperature control actuator is located at the heater unit. It regulates
the temperature by the procedure as follows. Signal from control unit adjusts positio ...
Repair procedures
Replacement
1.
Turn ignition switch OFF and disconnect the negative (-) battery terminal.
2.
Remove the battery.
(Refer to Engine Electrical System - "Battery")
3.
Remove the ECM.
(Refer to ...