| Inspection |
| 1. |
Check the tire pressure. 15(inch) : 230 kPa (33 psi) 16(inch) : 230 kPa (33 psi) 17(inch) : 230 kPa (33 psi) |
Tire Rotation
Checking For Pull And Wander
If the steering pulls to one side, rotate the tires according to the following wheel rotation procedure.
| 1. |
Rotate the front right and front left tires, and perform a road test in order to confirm vehicle stability.
|
| 2. |
If the steering pulls to the opposite side, rotate the front and rear tires, and perform a road test again.
|
| 3. |
If the steering continues to pull to one side, rotate the front right and left tires again, and perform a road test.
|
| 4. |
If the steering continues to pull to the opposite side, replace the front wheels with new ones.
|
Tire Wear
|
| 1. |
Measure the tread depth of the tires.
|
| 2. |
If the remaining tread depth (A) is less than the limit, replace the tire.
|
Repair procedures Inspection Visually check the loose mount bolt.
Repair procedures Smart Key Smart Key Code Saving 1. Connect the DLC cable of KDS/GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on KDS/GDS. 2. Select the vehicle model and then do "Smart key code saving".
Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.