Kia Rio: Starting System / Starter Relay

Repair procedures

Inspection
1.

Turn ignition switch OFF and disconnect the negative (-) battery terminal.

2.

Remove the fuse box cover.

3.

Remove the starter relay (A).

4.

Check for continuity between the terminals (30 and 87) using an ohmmeter.

Terminal
Resistance
Measure
30 - 87
1MΩ or higher
If there is continuity between the terminals, replace the relay.

5.

Apply 12V to the terminal 85 and ground to the terminal 86 and then check for continuity between the terminals (30 and 87).

Terminal
Resistance
Measure
30 - 87
1Ω or less
If there is no continuity between the terminals, replace the relay.

6.

Install the starter relay.

7.

Install the fuse box cover.

    Specifications Specification ▷12V, 1.2kW : ISG only Item Specification Rated voltage 12 V, 1.

    Description and operation Description The cruise control system is engaged by the cruise "ON/OFF" main switch located on right of steering wheel column.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Rear Wiper Motor

    Repair procedures Inspection Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect positive (+) battery cables to terminal 4 and negative (-) battery cables to terminal 3 respectively.

    Kia Rio 2017-2023 YB Service Manual: Blower Resistor (MANUAL)

    Repair procedures Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0184