Kia Rio: Body Side Molding / Roof Side Molding

Kia Rio 2017-2023 YB Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding

Repair procedures

Replacement
  

Put on gloves to protect your hands.

  
•

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

•

Take care not to bend or scratch the trim and panels.

1.

Using a remover, remove the roof side molding (A).

  

Always replace the roof side molding with a new one.

2.

Install in the reverse order of removal.

  

First assemble the clip ⓐ and then assemble the other clips from the ⓐ to ⓖ direction in sequence order.

    Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Parking Assist Sensor

    Components and components location Components Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper assembly. (Refer to Body - "Rear Bumper Assembly") 3.

    Kia Rio 2017-2023 YB Service Manual: Mode Control Actuator

    Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0189