Kia Rio: Rear Wiper/Washer / Rear Washer Switch
Repair procedures
Multifunction Switch
Inspection
1. |
Check for continuity between the terminals in each switch position as
shown below.

[Left Handle
Drive]
Switch
|
Switch position
|
Switch terminal
|
Resistance (Ω, ±3.5%)
|
Front wiper switch
|
MIST
|
1-9
|
330
|
OFF
|
∞
|
Intermittent (AUTO)
|
800
|
LOW
|
1,800
|
HIGH
|
5,700
|
Rear wiper switch
|
OFF
|
9-16
|
∞
|
LOW
|
910
|
HIGH
|
2,910
|
[Right Handle
Drive]
Switch
|
Switch position
|
Switch terminal
|
Resistance (Ω, ±3.5%)
|
Front Wiper switch
|
MIST
|
3-16
|
330
|
OFF
|
∞
|
Intermittent (AUTO)
|
800
|
LOW
|
1,800
|
HIGH
|
5,700
|
Rear wiper switch
|
OFF
|
9-16
|
∞
|
LOW
|
910
|
HIGH
|
2,910
|
|
Inspection (With KDS/GDS)
1. |
In the body electrical system, failure can be quickly diagnosed by using
the vehicle diagnostic system (KDS/GDS).
The diagnostic system(KDS/GDS) provides the following information.
(1) |
Self diagnosis : Checking failure and code number (DTC)
|
(2) |
Current data : Checking the system input/output data state
|
(3) |
Actuation test : Checking the system operation condition
|
(4) |
Additional function : Controlling other features including system
option setting and zero point adjustment
|
|
2. |
Select the 'Car model' and the 'Body Control Module (BCM)' to be checked
in order to check the vehicle with the tester.
|
3. |
Select the 'Current Data' menu to search the current state of the input/output
data.

|
1. |
Check for continuity between the terminals in each switch position as
shown below.

Rear Wiper
& Washer Switch
[LHD]

[RHD]

|
Repair procedures
Inspection
Rear Wiper Motor
1.
Remove the connector from the rear wiper motor.
2.
Connect positive (+) battery cables to terminal ...
Repair procedures
Inspection
1.
With the washer motor connected to the reservoir tank, fill the reservoir
tank with water.
&n ...
Other information:
Inside rearview mirror
Adjust the rearview mirror so that the center view through the rear window is
seen. Make this adjustment before you start driving.
Do not place objects in the rear seat which would interfere with your vision
through the rear window.
WARNING - Mirror adjustment
Do not a ...
1. Open the trunk lid.
2. Loosen the light assembly retaining screws with a cross-tip screwdriver.
3. Remove the rear combination lamp assembly from the body of the vehicle.
4. Disconnect the rear combination lamp connector.
5. Remove the socket from the assembly by turning the socket coun ...