Kia Rio: Rear Wiper/Washer / Rear Washer Motor
Repair procedures
| Inspection |
| 1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
| 2. |
Remove the engine room under cover. D 1.4 U2 TCI (Refer to Engine Mechanical System - "Engine Room Under Cover") G 1.0 T-GDI KAPPA (Refer to Engine Mechanical System - "Engine Room Under Cover") G 1.2 MPI KAPPA (Refer to Engine Mechanical System - "Engine Room Under Cover") G 1.4 MPI KAPPA (Refer to Engine Mechanical System - "Engine Room Under Cover") |
| 3. |
Remove the front wheel guard [RH]. (Refer to Body - "Front Wheel Guard") |
| 4. |
Connect positive (+) battery cables to terminal 3 and negative (-) battery cables to terminal 2 respectively. |
| 5. |
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles. |
| 6. |
If they are abnormal, replace the washer motor. [Front & Rear washer]
|
Repair procedures Inspection Multifunction Switch Inspection [BCM Type] 1. Check for continuity between the terminals in each switch position as shown below.
Specifications Specification Item Specification Ultrasonic sensor Voltage rating DC 12V Detecting range 11.
Other information:
Kia Rio 2017-2023 YB Service Manual: Power Door Mirror Actuator
Components and components location Components 1. Side repeater lamp Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door quadrant inner cover (A).
Kia Rio 2017-2023 YB Service Manual: Heater & A/C Control Unit (FATC)
Components and components location Components Connector Pin Function No. Connector A Connector B 1 Battery ⁻ 2 ISG battery (+) ⁻ 3 Illumination (+) ⁻
Categories
- Manuals Home
- Kia Rio Owners Manual
- Kia Rio Service Manual
- Steering System
- Clutch System
- CVVT & Camshaft
- New on site
- Most important about car
