| Component Location |

| 1. Rear transverse trim |
| Replacement |
Put on gloves to protect your hands. |
|
| 1. |
Remove the luggage covering (A).
|
| 2. |
Disconnect the tailgate weatherstrip. |
| 3. |
Remove the rear transverse trim (A).
|
| 4. |
Install in the reverse order of removal.
|
Components and components location Component Location 1. Center pillar lower trim 2. Center pillar upper trim Repair procedures Replacement [Center pillar lower trim] Put on gloves to protect your hands.
Components and components location Component Location 1. Luggage side trim Repair procedures Replacement Put on gloves to protect your hands.
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper assembly. (Refer to Body - "Front Bumper Assembly") 3. Remove the front fog lamp assembly (A) after loosening the mounting screws.
Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by signal from control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.