Kia Rio: Rear Door / Rear Door Latch

Kia Rio 2017-2023 YB Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Latch

Components and components location
Component Location

1. Rear door latch


Repair procedures
Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the rear door inside handle.

(Refer to Rear Door - "Rear Door Inside Handle")

2.

Remove the rear door window glass.

(Refer to Rear Door - "Rear Door Window Glass")

3.

Disconnect the rear door latch connector (A).

4.

Loosen the rear door latch & outside handle base mounting rod (A).

5.

Loosen the rear door latchmounting screws (A).

6.

Remove the rear door latch (A).

7.

Install in the reverse order of removal.

  

Check that glass operation is normal.

Check the damage glass channel, and replace if necessary.

Adjust glass if necessary.

Rear Door Outside Handle
Components and components location Component Location 1. Rear door outside handle Repair procedures Replacement ...

Rear Door Belt Outside Weatherstrip
Repair procedures Replacement 1. Pull down the rear door window glass to the lowest level by pressing the power window glass switch. 2. Remov ...

Other information:

Kia Rio 2017-2023 YB Service Manual: Manifold Absolute Pressure Sensor (MAPS)


Specifications Specification Manifold Absolute Pressure Sensor (MAPS) ▷ Type: Piezo-resistive pressure sensor type Pressure [kPa (kgf/cm², psi)] Output Voltage (V) [Vref = 5V] 20.0 (0.20, 2.9) 0.79 46. ...

Kia Rio 2017-2023 YB Owners Manual: Mode selection


The mode selection button controls the direction of the air flow through the ventilation system. Every time you press the mode selection button, the mode will change as follows: Refer to the illustration in the “Manual climate control system”. Face-Level (B, D) Air flow is directed t ...

Copyright © www.krioyb.com 2017-2023