| Component Location |

| 1. Quarter fixed glass |
| Replacement |
| 1. |
Pull down rear door window glass by pressing the power window glass switch. |
| 2. |
Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") |
| 3. |
Remove the door pull handle mounting support (A) after loosening the screws.
|
| 4. |
Disconnect the front door speaker connector (A), and then remove the wiring mounting clips.
|
| 5. |
Remove the front door trim seal (A).
|
| 6. |
Remove the front door belt inside weather strip (A).
|
| 7. |
Remove the front door belt outside weather strip (A).
|
| 8. |
Separate the door side weatherstrip (A).
|
| 9. |
Loosen the mounting screw and bolt.
|
| 10. |
Remove the quarter fixed glass & molding (A).
|
| 11. |
Remove the rear door molding (A).
|
| 12. |
Remove the quarter fixed glass (A).
|
| 13. |
Install in the reverse order of removal.
|
Repair procedures Replacement 1. Remove the sunroof assembly. (Refer to Sunroof - "Sunroof Assembly") 2.
Components and components location Components 1. Rear bumper cover assembly 2. Rear bumper side bracket assembly [RH] 3.
Components and components location Components Connector Pin Information No. Connector A Connector B Connector C 1 - IGN2 Relay_output Battery (+)_Signal 2 SSB Switch1 signal_input P-CAN
Repair procedures Inspection 1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor) Replacement 1.