
■ Type A

■ Type B
Distance To Empty (1)
• The range is the estimated distance the vehicle can be driven with the remaining fuel.
- Distance range : 1 ~ 9,999 km or 1 ~ 99,999 mi.
• If the estimated distance is below 1 km (1 mi.), the trip computer will display “---” as distance to empty.
✽ NOTICE
Average Fuel Economy (2)
• The average fuel economy is calculated by the total driving distance and fuel consumption since the last average fuel economy reset.
- Fuel economy range: 0.0 ~ 99.9 L/100 km, km/L or MPG
• The average fuel economy can be reset both manually and automatically.
Manual reset
To clear the average fuel economy manually, press the RESET (for Type A cluster), OK ( for Type B cluster) (reset) on the steering wheel for more than 1 second when the average fuel economy is displayed.
Automatic reset (for type B cluster) To make the average fuel economy be reset automatically whenever refueling, select the “Fuel economy auto reset” mode in the User Setting menu of the LCD window (Refer to “LCD window”).
✽ NOTICE
The average fuel economy is not displayed for more accurate calculation if the vehicle does not drive more than 10 seconds or 50 meters (0.03 miles) since the ignition switch or Engine Start/Stop button is turned to ON.
Instant Fuel Economy (3)
• This mode displays the instant fuel economy during the last few seconds when the vehicle speed is more than 10 km/h (6.2 mph).
- Fuel economy range: 30.0 L/100 km or 0.0 ~ 50.0 MPG
- For Type A cluster To change the trip mode, press the TRIP button. - For Type B cluster To change the trip mode, scroll the MOVE scroll switch ( ) in the trip computer mode.
Tripmeter (1) The tripmeter is the total driving distance since the last tripmeter reset. - Distance range : 0 ~ 1599999 km or 0 ~ 999999 mi To reset the tripmeter, press the RESET button on the steering wheel for more than 1 second when the tripmeter is displayed.
Components and components location Components Connector Pin Information No. Connector A Connector B Connector C 1 - IGN2 Relay_output Battery (+)_Signal 2 SSB Switch1 signal_input P-CAN
Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by signal from control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.