| Component Location |
| E/R Junction Block |

| Circuit (PCB Block) |

| E/R Junction Block |

| Circuit (PCB Block) |

| E/R Junction Block |

| Circuit (PCB Block) |

| E/R Junction Block |

| Circuit (PCB Block) |

| Gasoline / Diesel Junction Block |

| Inspection |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Pull out the relay from the engine compartment relay block. |
Power Relay (Type A)
Check for continuity between the terminals.
| 1. |
After supplying power to between No. 85 and 86 power relay terminals, check that there is continuity between No. 30 and 87 terminals. |
| 2. |
After disconnecting power between No. 85 and 86 power relay terminals, check that there is no continuity between No. 30 and 87 terminals. Engine Room Relay Block
|
Power Relay (Type B)
Check for continuity between the terminals.
| 1. |
After supplying power to between No. 85 and 86 power relay terminals, check that there is continuity between No. 30 and 87 terminals. |
| 2. |
After disconnecting power between No. 85 and 86 power relay terminals, check that there is no continuity between No. 30 and 87 terminals.
|
Fuse
| 1. |
Check that the fuse holders are loosely held and that the fuses are securely fixed by the holders. |
| 2. |
Check that each fuse circuit has the exact fuse capacity. |
| 3. |
Check the fuses for any damage.
|
Multi Fuse
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the power cable terminals (A) after loosening the nuts from the engine room fuse & relay box.
|
| 3. |
Remove the multi fuse (A) after pushing the hook.
|
|
Components and components location Component Location [Engine Room] 1. Engine room relay block [Interior Relay] 1.
Components and components location Component Location I/P Junction Block Circuit (I/P Junction Block) Repair procedures Fuse Inspection 1.
Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shroud panel.
Components and components location Components Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console and remove the 2 screws holding the overhead console.