Kia Rio: Body Electrical System / Ignition Switch

Kia Rio 2017-2025 YB Service Manual / Body Electrical System / Ignition Switch

Repair procedures
Inspection
1.

Disconnect the key warning switch connector (A) and ignition switch connector (B) from the steering column.

2.

Check for continuity between the terminals.

3.

If continuity is not specified, replace the switch.

Removal
1.

Disconnect the negative (-) battery terminal.

2.

Remove the crash pad lower panel.

(Refer to Body - "Crash Pad Lower Panel")

3.

Remove the steering column upper and lower shroud panel.

(Refer to Body - "Steering Column Shroud Panel")

4.

Remove the multifunction switch.

(Refer to Body Electrical System - "Multifunction Switch")

5.

Remove the ignition switch connector (A) and key warning / immobilizer connector (B).

6.

Insert key and turn it to ACC position.

7.

Pushing lock pin (A) with the awl.

8.

Remove the key lock cylinder (A).

B : Key warning switch

C : Ignition switch connector

9.

Remove the ignition switch (A) after loosening the mounting bolts.

Installation
  

Do not reuse the shear bolts.

When installing the new shear bolts to the ignition switch assembly, tighten the shear bolts until its head is cut off.

1.

Install the ignition switch.

2.

Install the key lock cylinder.

3.

Connect the ignition switch connector and key warning / immobilizer connector.

4.

Install the multifunction switch.

5.

Install the steering column upper and lower shroud panel.

6.

Install the crash pad lower panel.

7.

Connect the negative (-) battery terminal.

Horn
Components and components location Component Location 1. Horn switch 2. Horn relay 3. Horn 4. Clock spring Repair procedures Removal ...

Immobilizer System
Schematic diagrams Circuit Diaram Description and operation Description The immobilizer system will disable the vehicle unless the proper ignition key is used, in add ...

Other information:

Kia Rio 2017-2025 YB Owners Manual: Stop and tail lamp / Side marker (Bulb type) replacement (for 4 door)


1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 4. Remove the bulb from the socket by pressing it in and rota ...

Kia Rio 2017-2025 YB Service Manual: Front Wheel Speed Sensor


Components and components location Components 1. Front wheel speed sensor connector 2. Front wheel speed sensor Repair procedures Removal 1. Remove the front wheel & tire. Tightening torque: ...

Copyright © www.krioyb.com 2017-2025