Kia Rio: ABS(Anti-Lock Brake System) / Front Wheel Speed Sensor

Kia Rio 2017-2025 YB Service Manual / Brake System / ABS(Anti-Lock Brake System) / Front Wheel Speed Sensor

Components and components location
Components

1. Front wheel speed sensor connector
2. Front wheel speed sensor

Repair procedures
Removal
1.

Remove the front wheel & tire.

Tightening torque:

107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94.0 lb·ft)

2.

Loosen the bolt (A) and then disconnect the wheel speed sensor.

Tightening torque :

7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

3.

Remove the front wheel guard.

(Refer to Body - "Front Wheel Guard")

4.

Disconnect the wheel speed sensor connector (A).

5.

Install in the reverse order of removal.

Inspection
1.

Measure the output voltage between the terminal of the wheel speed sensor and the body ground.

  

In order to protect the wheel speed sensor, when measuring output voltage, a 100 Ω resister must be used as shown.

2.

Compare the change of the output voltage of the wheel speed sensor to the normal change of the output voltage as shown below.

V_low : 0.59V - 0.84V

V_high : 1.18V - 1.68V

Frequency range : 1 - 2,500Hz

ABS Control Unit
Components and components location Components 1. ABS control module connector 2. ABS control module 3. ABS bracket Repair procedures Remo ...

Rear Wheel Speed Sensor
Components and components location Components Drum type Disc type Repair procedures Removal 1. Remove the rear wheel & tire. ...

Other information:

Kia Rio 2017-2025 YB Owners Manual: Power window lock button


The driver can disable the power window switches on the rear passengers' doors by pressing the power window lock switch to the lock position (pressed). When the power window lock switch is pressed: The driver's master control can operate all the power windows. The front passenger's contro ...

Kia Rio 2017-2025 YB Owners Manual: Operating door locks from inside the vehicle


With the door lock button To unlock a door, pull the door lock button (1) to the “Unlock” position. The red mark on the button will be visible. To lock a door, push the door lock button (1) to the “Lock” position. If the door is locked properly, the red mark on the door lock bu ...

Copyright © www.krioyb.com 2017-2025