Kia Rio: Front Door / Front Door Belt Inside Weatherstrip

Repair procedures

Replacement
1.

Remove the front door trim.

(Refer to Front Door - "Front Door Trim")

2.

Remove the front door belt inside weatherstrip (A).

3.

Install in the reverse order of removal.

  

Replace any damaged clips.

Make sure that the connector is connected properly.

Make sure that the door locks/unlocks and opens/croses properly.

    Components and components location Component Location 1. Front door latch Repair procedures Replacement    Put on gloves to protect your hands.

    Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Compressor

    Description and operation Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of engine. The compressor changes the low pressure and low temperature refrigerant gas into the high pressure and high temperature refrigerant gas.

    Kia Rio 2017-2023 YB Service Manual: Mode Control Actuator

    Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0148