Kia Rio: Button Engine Start System / ESCL(Electronic Steering Column Lock)

Kia Rio 2017-2025 YB Service Manual / Body Electrical System / Button Engine Start System / ESCL(Electronic Steering Column Lock)

Components and components location

Component

Repair procedures

Removal

1.	Disconnect the negative(-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel")

3.	Remove the steering column upper and lower shrouds. (Refer to Body - "Steering Column Shroud Panel")

4.	Disconnect the electronic steering column lock connector (A).

5.	Remove the electronic steering column lock (A). (Refer to Steering System - "Steering Column and Shaft")

Installation

Install the electronic steering column lock.

•	Do not reuse the shear bolts.

•	When installing the new shear bolts to the electronic steering column lock, tighten the shear bolts until its head is cut off.

Tightening torque :

7.0 - 13.0 N·m (0.7 - 1.3 kgf·m, 5.0 - 9.4 lb·ft)

2.	Install the steering column.

3.	Install the crash pad lower panel.

Start/Stop Button

Components and components location Component Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove ...

Electro Chromic Inside Rear View Mirror

Components and components location Components Description and operation Description The ECM (Electro Chromatic inside rear view Mirror) is one that automatically dims ...

Other information:

Kia Rio 2017-2025 YB Owners Manual: Stop and tail lamp / Side marker (Bulb type) replacement (for 4 door)

1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 4. Remove the bulb from the socket by pressing it in and rota ...

Kia Rio 2017-2025 YB Service Manual: Immobilizer Control Unit

Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly") 3. Disconnect the connector of the immobilizer unit ...