Kia Rio: Electronic stability control (ESC) / ESC operation off

Kia Rio 2017-2024 YB Owners Manual / Driving your vehicle / Brake system / Electronic stability control (ESC) / ESC operation off

ESC OFF state

This car has 2 kinds of ESC off states.

If the engine stops when ESC is off, ESC remains off. Upon restarting the engine, the ESC will automatically turn on again.

• ESC off state 1 : “Traction Control disabled”

To turn off the traction control function and only operate the brake control function of the ESC, press the ESC OFF button (ESC OFF ) for less than 3 seconds and the ESC OFF indicator light (ESC OFF ) will illuminate. At this state, only the brake function will operate.

• ESC off state 2 : “Traction & Stability Control disabled”

To turn off the traction control function and the brake control function of the ESC, press the ESC OFF button (ESC OFF ) for more than 3 seconds. ESC OFF indicator light (ESC OFF ) will illuminate and ESC OFF warning chime will sound. In this state, the car stability control function will not operate.

ESC operation
ESC ON condition When the ignition is turned ON, ESC and ESC OFF indicator lights illuminate for approximately 3 seconds, then ESC is turned on. Press the ESC OFF button for at least half a ...

Indicator light
When the ignition switch is turned ON, the indicator light illuminates, then goes off if ESC system is operating normally. The ESC indicator light blinks whenever ESC is operating or illuminates ...

Other information:

Kia Rio 2017-2024 YB Service Manual: Drive Belt Tensioner


Repair procedures Removal and Installation 1. Remove the engine room under cover. (Refer to Engine and Transaxle Assembly - "Engine Room Under Cover") 2. Remove the drive belt. (Refer to Drive Belt System - "Drive Belt" ...

Kia Rio 2017-2024 YB Owners Manual: Headlamp (Low/High beam) (Bulb type) bulb replacement (Headlamp Type A)


1. Open the hood. 2. Remove the headlamp bulb cover by turning it counterclockwise. 3. Disconnect the headlamp bulb socket-connector. 4. Unsnap the headlamp bulb retaining wire by pressing the end and pushing it upward. 5. Remove the bulb from the head lamp assembly. 6. Install a new headla ...

Copyright © www.krioyb.com 2017-2024