Kia Rio: Indicator Lights / Electronic Stability Control (ESC) Indicator Light
This indicator light illuminates:
- Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It illuminates for approximately 3 seconds and then goes off. - When there is a malfunction with the ESC system.
In this case, have your vehicle inspected by an authorized Kia dealer.
This indicator light blinks:
While the ESC is operating.
❈For more details, refer to “Electronic Stability Control (ESC)” in chapter 6.
Electronic Stability Control (ESC) OFF Indicator Light This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position.
Other information:
Kia Rio 2017-2023 YB Service Manual: Rear Washer Switch
Repair procedures Inspection Multifunction Switch Inspection [BCM Type] 1. Check for continuity between the terminals in each switch position as shown below. [Left Handle Drive] Switch Switch position Switch terminal
Kia Rio 2017-2023 YB Service Manual: Mode Control Actuator
Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Categories
- Manuals Home
- Kia Rio Owners Manual
- Kia Rio Service Manual
- Engine Mechanical System
- Maintenance
- Clutch System
- New on site
- Most important about car
