Kia Rio: Manual Transaxle Control System / Control Shaft Complete

Kia Rio 2017-2023 YB Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Shaft Complete

Components and components location

Components Location

1. Control shaft complete

Repair procedures

Removal

1.	Shift the gear to "neutral".

2.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

3.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

4.	Remove the control cable from the control shaft after remove the pins (A).

Remove the control shaft complete (A).

Tightening torque :

19.6 - 26.5 N.m (2.0 - 2.7 kgf.m,14.5 - 19.5 lb-ft)

Installation

1.	Install in the reverse order of removal.

•	Install the control shaft complete after setting the neutral state.

•

Apply the sealant to the contact surface of transaxle and control shaft.

Specified sealant : Anaerobic adhesive for flange

❮Manual Transaxle Control System

Shift Lever❯

Components and components location Components 1. Knob 2. boots 3. Shift lever assembly 4. Retainer 5.

Other information:

Kia Rio 2017-2023 YB Service Manual: Mode Control Actuator

Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

Kia Rio 2017-2023 YB Service Manual: PTC Heater