| Component Location |

| 1. Console armrest |
| Replacement |
Put on gloves to protect your hands. |
|
| 1. |
Remove the floor console assembly. (Refer to Floor Console - "Floor Console Assembly") |
| 2. |
Remove the rear console cover. (Refer to Floor Console - "Rear Console Cover") |
| 3. |
Loosen the mounting screws (A) and remove the console armrest (B).
|
| 4. |
Install in the reverse order of removal.
|
Components and components location Component Location 1. Rear console cover Repair procedures Replacement Put on gloves to protect your hands.
Components and components location Components 1. Front bumper cover assembly 2. Front bumper lower stiffener 3.
Repair procedures Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Remove the glass motor (A) after loosening the mounting screws.
Description and operation Description The intake actuator is located at the blower unit. It regulates the intake door by signal from control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes.