Kia Rio: Body Electrical System / Back View Camera System

Kia Rio 2017-2023 YB Service Manual / Body Electrical System / Back View Camera System

Components and components location

Component Location

1. Back view camera
2. AVN head unit

3. Steering angle sensor

Description and operation

Description

1.	To display back of the vehicle to assist the driver, it receives vehicle rearside image signal from the rearview camera and displays it on AVN head unit monitor or LHS of inside rearview mirror.

2.	Back view camera is a supplementary device that displays dead zone on monitor screen that automatically operates when the gear stays in "R" for over 3 seconds.

3.	It displays the estimated trajectory with parking guideline in accordance with the operating angle of steering wheel. (There is no separate unit.)

System Structure (Back view camera operated by steering)

Schematic diagrams

Circuit Diagram

Repair procedures

Removal

In case of bad quality or poor focus, be sure to check the camera lense surface condition and foreign materials.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the tailgate trim. (Refer to Body - "Tailgate Trim")

3.	Disconnect the tailgate outside handle assembly connector (A).

4.	Remove the tailgate outside handle assembly (A) after loosening the mounting nuts.

5.	Disconnect the back view camera assembly connector (A).

6.	Remove the back view camera assembly (B) after loosening the mounting screws.

Installation

1.	Connect the back view camera assembly connector.

2.	Install the back view camera assembly.

3.	Install the tailgate outside handle assembly.

4.	Connect the tailgate outside handle assembly connector.

5.	Install the tailgate trim.

6.	Connect the negative (-) battery terminal.

❮Mic

Repair procedures Inspection 1. Disconnector the negative (-) battery terminal. 2. Remove the overhead console lamp.

Body Control Module (BCM)❯

Specifications Specifications [BCM Type] Items Specifications Rated voltage DC 12 V Operating voltage DC 9 - 16 V Operating temperature -31 - 167°F (-35 - 75°C) Dark current SMK : 3mA / Keyless : 3.

Other information:

Kia Rio 2017-2023 YB Service Manual: Rear Wiper Motor

Repair procedures Inspection Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect positive (+) battery cables to terminal 4 and negative (-) battery cables to terminal 3 respectively.

Kia Rio 2017-2023 YB Service Manual: Compressor

Description and operation Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of engine. The compressor changes the low pressure and low temperature refrigerant gas into the high pressure and high temperature refrigerant gas.