Kia Rio: Body (Interior and Exterior) / Trunk Trim

Kia Rio 2017-2025 YB Service Manual / Body (Interior and Exterior) / Trunk Trim

Components and components location
Components

1. Rear transverse trim
2. Luggage covering mat
3. Luggage floor net
4. Luggage side trim [RH]
5. Rear wheel house trim [RH]
6. Luggage partition side trim [RH]
7. Rear wheel house trim [LH]
8. Rear package tray trim
9. Rear wheel house trim [LH]

Repair procedures
Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Take care not to bend or scratch the trim and panels.

1.

Remove the rear seat assembly.

(Refer to Rear Seat - "Rear Seat Assembly")

2.

Remove the rear pillar trim (A) by using a remover.

3.

Remove the rear door scuff trim.

4.

Remove the rear partition trim (A) after looseing the mountin screw.

5.

Remove the luggage side trims mounting clips (A).

6.

Remove the luggage covering (A).

7.

Separate the tailgate weatherstrip.

8.

Remove the rear transverse trim (A).

9.

Remove the luggage side trim (A) after loosening the screws and clips.

10.

Install in the reverse order of removal.

  

Make sure that the connector is connected properly.

Replace any damage clips.

Trunk Lid Weatherstrip
Repair procedures Replacement (5Door)    Be careful as the tailgate may fall down on people when the lifts ...

Windshield Glass
Components and components location Components 1. Windshield glass 2. Windshield glass molding Repair procedures Removal ...

Other information:

Kia Rio 2017-2025 YB Service Manual: ISG OFF switch


Components and components location Components Description and operation Description The ISG OFF switch on the floor console can be used to deactivate the ISG function. Schematic diagrams Circuit Diagram Repair procedures Removal ...

Kia Rio 2017-2025 YB Owners Manual: Engine oil


Checking the engine oil level ■ Gamma II 1.6L MPI (Gasoline engine) 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan. ...

Copyright © www.krioyb.com 2017-2025