Kia Rio: Tires and wheels / Tire pressure

Kia Rio 2017-2020 YB Owners Manual / Maintenance / Tires and wheels / Tire pressure

Always observe the following:

WARNING - Tire Inflation

Overinflation or underinflation can reduce tire life, adversely affect vehicle handling, and lead to sudden tire failure. This could result in loss of vehicle control and potential injury.

Checking tire inflation pressure

Check your tires once a month or more.

Also, check the tire pressure of the spare tire.

How to check

Use a good quality gauge to check tire pressure. You cannot tell if your tires are properly inflated simply by looking at them. Radial tires may look properly inflated even when they're underinflated.

Check the tire's inflation pressure when the tires are cold. - “Cold” means your vehicle has been sitting for at least three hours or driven no more than 1.6 km (1 mile).

Remove the valve cap from the tire valve stem. Press the tire gauge firmly onto the valve to get a pressure measurement. If the cold tire inflation pressure matches the recommended pressure on the tire and loading information label, no further adjustment is necessary. If the pressure is low, add air until you reach the recommended amount.

If you overfill the tire, release air by pushing on the metal stem in the center of the tire valve. Recheck the tire pressure with the tire gauge. Be sure to put the valve caps back on the valve stems. They help prevent leaks by keeping out dirt and moisture.

Tires and wheels
Tire care For proper maintenance, safety, and maximum fuel economy, you must always maintain recommended tire inflation pressures and stay within the load limits and weight distribution recommend ...

Tire rotation
To equalize tread wear, it is recommended that the tires be rotated every 12,000 km (7,500 miles) or sooner if irregular wear develops. During rotation, check the tires for correct balance. When r ...

Other information:

Kia Rio 2017-2020 YB Owners Manual: Back-up lamp bulb replacement (for 5 door)


1. Open the liftgate. 2. Remove the service cover. 3. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 4. Remove the bulb from bulb-socket by pulling it out. 5. Insert a new bulb by inserting it in ...

Kia Rio 2017-2020 YB Service Manual: Inhibitor Switch


Description and operation Description Detect the position of shift lever through the contact switch. Operation Table Schematic diagrams Circuit Diagram Repair procedures Inspection 1. Check the condition of connector. ...

Copyright © www.krioyb.com 2017-2020