Kia Rio: Seat belt restraint system / Seat belt warning

As a reminder to the driver, the driver’s seat belt warning lights will illuminate
and warning chime will sound for approximately 6 seconds each time you turn the
ignition switch ON regardless of belt fastening.
If the driver’s seat belt is not fastened when the ignition switch is turned
ON or if it is disconnected after the ignition switch is turned ON, the seat belt
warning light will illuminate until the belt is fastened.
If you continue not to fasten the seat belt and you drive over 9 km/h (6 mph),
the illuminated warning light will illuminate.
If you continue not to fasten the seat belt and you drive over 20 km/h (12 mph),
the seat belt warning chime will sound for approximately 100 seconds and the corresponding
warning light will blink.
If you unfasten the seat belt while driving under 20 km/h (12 mph), the seat
belt warning light will illuminate until the seat belt is fastened.
Seat belts are designed to bear upon the bony structure of the body, and should
be worn low across the front of the pelvis, chest and shoulders, as applicable;
wearing the lap section of the belt ...
To fasten your seat belt:
To fasten your seat belt, pull it out of the retractor and insert the metal tab
(1) into the buckle (2). There will be an audible "click" when the tab locks into
the b ...
Other information:
Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the license lamp assembly (A) after pressing the locking pin.
3.
Disconnect the license lamp connector (A).
...
Type A
Type B
Fog lights are used to provide improved visibility when visibility is poor due
to fog, rain or snow, etc. The fog lights will turn on when the fog light switch
(1) is turned to the on position after the headlights are turned on.
To turn off the fog lights, turn the switch ...