Kia Rio: Towing / Removable towing hook (front)

1. Remove the towing hook from the tool case located in the trunk/liftgate.
2. Remove the hole cover pressing the lower part of the cover on the front bumper.
3. Install the towing hook by turning it clockwise into the hole until it is
fully secured.
4. Remove the towing hook and install the cover after use.
Towing service
If emergency towing is necessary, we recommend having it done by an authorized
Kia dealer or a commercial tow-truck service. Proper lifting and towing procedures
are necessary to ...
• Front
• Rear (4 Door)
• Rear (5 Door)
If towing is necessary, we recommend you have it done by an authorized Kia
dealer or a commercial tow truck service.
If towing service is not ...
Other information:
Operates as follows when the ignition switch is turned ON.
MIST : For a single wiping cycle, push the lever upward and release it. The wipers
will operate continuously if the lever is held in this position.
OFF : Wiper is not in operation
INT : Wiper operates intermittently at the same wiping i ...
This warning light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.
- It illuminates for approximately 3 seconds
When the parking brake is applied.
When the brake fluid level in the reservoir is low.
- If the warning light illuminates with t ...