Kia Rio: Interior Trim / Rear Pillar Trim

Kia Rio 2017-2023 YB Service Manual / Body (Interior and Exterior) / Interior Trim / Rear Pillar Trim

Components and components location
Component Location
[5 Door]

1. Rear pillar trim

[4 Door]

1. Rear pillar trim

Repair procedures
Replacement
[5 Door]
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Take care not to bend or scratch the trim and panels.

1.

Remove the luggage side trim.

(Refer to Interior Trim - "Luggage Side Trim")

2.

Remove the rear pillar trim (A).

3.

Install in the reverse order of removal.

  

Replace any damaged clips.

Once the trim has been removed replace the clip (B) with a new one.

[4 Door]
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Take care not to bend or scratch the trim and panels.

1.

Fold the rear seat back assembly.

2.

Remove the rear pillar trim (A) by using a remover.

3.

Install in the reverse order of removal.

  

Replace any damaged clips.

Once the trim has been removed replace the clip (B) with a new one.

Luggage Side Trim
Components and components location Component Location 1. Luggage side trim Repair procedures Replacement &nbs ...

Rear Wheel House Trim
Components and components location Component Location 1. Rear wheel house trim Repair procedures Replacement &nbs ...

Other information:

Kia Rio 2017-2023 YB Owners Manual: Mode selection


The mode selection knob controls the direction of the air flow through the ventilation system. Air can be directed to the floor, dashboard outlets, or windshield. Five symbols are used to represent Face, Bi-Level, Floor, Floor-Defrost and Defrost air position. Face-Level (B, D) Air flow i ...

Kia Rio 2017-2023 YB Owners Manual: Rear turn signal lamp bulb replacement (for 5 door)


1. Open the trunk lid. 2. Loosen the light assembly retaining screws with a cross-tip screwdriver. 3. Remove the rear combination lamp assembly from the body of the vehicle. 4. Disconnect the rear combination lamp connector. 5. Remove the socket from the assembly by turning the socket coun ...

Copyright © www.krioyb.com 2017-2023