Kia Rio: Rear Door / Rear Door Power Window Regulator

Components and components location

Component Location

1. Rear door trim


Repair procedures

Replacement
  

Put on gloves to protect your hands.

  

Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

Be careful not to bend or scratch the trim and panels.

1.

Remove the rear door window glass.

(Refer to Rear Door - "Rear Door Window Glass")

2.

Disconnect the rear door power window motor connector (A).

3.

Loosen the rear door power window regulator mounting nuts.

Tightening torque :

3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

4.

Remove the rear door power window regulator (A).

5.

Install in the reverse order of removal.

  

Check that glass operation is normal.

Check the damage glass channel, and replace if necessary.

Adjust glass if necessary.

    Components and components location Component Location 1. Rear door window glass Repair procedures Replacement    Put on gloves to protect your hands.

    Components and components location Component Location 1. Rear door outside handle Repair procedures Replacement    Put on gloves to protect your hands.

    Other information:

    Kia Rio 2017-2023 YB Service Manual: Antenna Coil

    Repair procedures Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the steering column upper and lower shroud panel.

    Kia Rio 2017-2023 YB Service Manual: Mode Control Actuator

    Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

    Categories

     
    Copyright © 2026 www.krioyb.com - 0.0178