| Replacement |
Put on gloves to protect your hands. |
|
| 1. |
Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") |
| 2. |
Separate the inside handle (A) after loosening the mounting screw.
|
| 3. |
Remove the front door inside handle (B) after disconnecting the cable (A).
|
| 4. |
Install in the reverse order of removal.
|
Components and components location Component Location 1. Rear door trim Repair procedures Replacement Put on gloves to protect your hands.
Components and components location Component Location 1. Rear door window glass Repair procedures Replacement Put on gloves to protect your hands.
Repair procedures Inspection Front Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. • Before filling the reservoir tank wi
Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.